MT-350 is a GSM Fixed Wireless Terminals that has FXS,FXO,GSM*1 interface. It can connect with PBX,PSTN or VoIP Gateway.

MT-350C: CDMA Gateway / CDMA Cellular Gateway (FXS,FXO,GSM)

MT-350S-->Add SMS Function(Short message Service)

Catalog (419KB) User manual(487KB) MTSMS manual(109KB)
 
MT-350
Where to buy? 
  
<<Function Description>> 
1. Conversion of wire & wireless communication
2. Auto-select economic route
3.Code Conversion Setting :Through the connection towards local PSTN line, the phone calls will proceed with code-transfer dialing process.
4. Vocal volume modulating system
5.Set the Allow-to-Dial Code (GSM Prefix No.Setting (50 sets))
6.Set GSM dial-out code amount
7.Polarity reversing function
8.Definition of DTMF reversing signal
9.Limit of communicating time
10. GSM function of dialing out the prompt voice
11.When not connecting to Telephone Office line, GSM will provide the forced dial-out function
12.Set up GSM extra dialing local code
13.Set up extra dialing local-code to PSTN
14.GSM simulated echo-bell-sound function
15.GSM isn¡¦t ready, call will be forced to dial out from PSTN
16.Call-transfer: (MT-350C doesn't have this function.)
 

- PSTN to GSM:
¡@ An incoming call of PSTN will be transferred to specify GSM no.
- GSM to PSTN:
¡@1. GSM in PSTN out, give you a prompt "du" and you can enter any destination ¡@
¡@¡@ number ¡@
¡@2.An incoming call of GSM will be transferred to specify PSTN no.

17.MT-350C: CDMA 2000(800MHz)
17..MT-350 -GSM Frequency bands:
Dual band:900/1800MHZ
Tri band:850/1800/1900MHZ
 
<<Full Automatic Economic Router>>
         ¡uMT-350¡vhas the function to choose route automatically. When you dial out from your ¡§MT-350¡¨, it will check if this is belong to the Inter-Network number automatically. If yes, then it will dial out from the mobile and send two ¡§beep¡¨ tones to ensure it really dial out from the mobile. If not, it will still dial out from the Central Office, CO line; it will dial out from your mobile without distinguishing if you don¡¦t connect the CO line.
 
<<Specification>> 
Phone Impedance¡GBelow DC 1k£[¡AAC 600£[¡C(not include line)
Phone Ring Output Voltage¡G45V rms¡C
Phone Signal (DTMF) Standard¡G-3dbm¡ã-24dbm¡C
Phone Signal (DTMF)Time¡G50¡ã100ms¡C
DTMF Frequency Rate Error¡G¡Ó1¢H¡C
Feeder Voltage¡G48V¡C
AC Adapter¡GInput 110V AC¡AOutput 12V DC 1A¡C
GSM Specification ¡G
 I. GSM Frequency bands:Dual Band EGSM 900 and GSM 1800(GSM Phase 2+)
 II. GSM class: Small MS
 III. Transmit power:
     Class 4(2W) for EGSM 900
     Class 1(1W) for GSM 1800
 IV. SIM card reader: External ¡V connected via interface connector
 V. Antenna: 50 Ohm antenna coaxial connector
 VI. Temperature range :
     Normal operation: -20¢J to +55¢J
     Restricted operation:-25¢J to -20¢J and +55¢J to 70¢J
     Storage:-40¢J to +85¢J